Bearded Dragon Vivarium

Setting up a Bearded Dragon Vivarium (enclosure).

 

Welcome to www.crazyreptile.com,

I really do hope that these instructions help you postions most of the equipment in the vivarium. These instruction are based on a wooden vivexotic but I think it will mostly work for many wooden vivarium brands.

 

Where do I start ?

  1. Firstly you will need to construct you vivarium if not constructed but if constructed please jump to step 2.

    (Must leave vivarium lid off until told so.

 

  1. If your vivarium is already built you need to seal all joints with clear silicone.

 

  1. Next move vivarium into final position.

 

  1. Now plug in your extension lead and plug in the two timers. (leave extension lead turned off).

 

  1. Now screw in the ARCADIA CERAMIC LAMP HOLDER AND BRACKET.

 

  1. Next screw in the Exo-Terra Ceramic Heat Wave Reptile Basking Lamp 120w into the ARCADIA CERAMIC LAMP HOLDER AND BRACKET.

 

  1. Now fit the Arcadia starter unit 25 to 30 watt.

 

  1. Next push in the 6” repti- glo 10.0 UV tube.

     

  2. Make sure all wire come out the vivarium slot/ grove on back piece of wood. If you have not got one you need to cut out an grove on the back piece of wood.

 

  1. Next stick on one thermometer at basking spot near basking bulb. (Left end of vivarium).

 

  1. Next stick on the other thermometer at cool end (right end of vivarium).

     

  2. Now put in your selected substrate cover all of the floor area in vivarium.

     

  3. Now add you dècore where ever you want.

     

  4. Now Screw down lid of vivarium.( Make sure all wires are in the grove).

     

  5. Next plug in the UV stater unit into the timer.

     

  6. Next plug in the Living Earth electronic : dimming thermostat habistat plug into the timer.

     

  7. Next plug in the ARCADIA CERAMIC LAMP HOLDER AND BRACKET into the Living Earth electronic : dimming thermostat habistat plug.

     

  8. Make sure the living Earth electronic : dimming thermostat habistat box with the twisting nob is on top of the vivarium or on the side of the vivarium but must be able to reach or use.

     

  9. Now turn on the mains to your extension lead.

     

  10. Now set the timers and set the living Earth electronic : dimming thermostat habistat.

     

  11. Turn on the switch on the UV starter unit.

     

  12. Add food and water dishes. Your vivarium set up should be finished.